How to Remove Links From a Seiko Watch Band
- 1). Turn the watch band on its side so that the links are vertical. If you look on the inside of the links that are closest to the clasp, you will see arrows that tell you which direction the pins that hold the links together must be pushed out. If you look on the edge of the link on the opposite end from where the arrows are pointing, you will see small circles where the pin is inserted.
- 2). Put the tip of your sharp tool on the pin head mentioned in Step 1. Push down on the pinhead forcefully in the direction the arrow is pointing until the pin comes out the other end. Complete this step again on the pin next to the one you just removed.
- 3). Remove the loose link that does not have any pins holding it on the watch band. Remember to store the extra link and pin in a safe place because you may need to use them in the future.
- 4). Slide the watch band back together by lining up the pin holes. Insert the pin into the hole on the opposite end from where the arrow is pointing. Use your sharp tool to push the pin through the links until the pin head is flush with the edge of the link.
Source...